HP StorageWorks XP24000/XP20000 Remote Web Console Error Codes (AE131-96014, September 2007)

Part
Code
Error
Number
Error Message
Recommended Action
Severity
Level
Failure
Level
1005 1023
An error occurred. If this
problem persists, please call
technical support.
If this problem persists, call
technical support.
E
2
1005
1024
An error occurred. If this
problem persists, please call
technical support.
Fibre topology information is
invalid. (The specified value
is not
in the specification.)
The error does not occur
normally because it is
guarded in the screen.
In the
unlikely event that
this error occurs, contact
technical support.
E
2
1005 1025
The specified LU path does
not exist.
The Configur
ation
information has been
already changed.
Please check the settings
and
reque
st the
setting of the
configuration information
again.
E
6
1005 1028
The number of volumes you
intend to combine into a
LUSE volume exceeds the
maximum.
The Configuration
information has been
already changed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
1005 1029
An error occurred during
SVP p rocessing. If this
problem persists, please call
technical support.
If this problem persists, call
technical support.
E
2
100
5
105
0
The following volumes
cannot
be specified when
you change expanded LU
configurations:
•
Volumes reserved by
Auto L UN
The C
onfiguration
information has been
already changed.
Please check the settings
and
request the setting of the
configuration information
again.
E
6
1005 1059
An error occurred. If this
problem persists, please call
technical support.
You are trying to perform
LUN Manager operation for
non-Fibre port. The error
does
not occur normally
because it is guarded in
the
screen. In the unlikely
eventthatthiserror occurs,
contact technical support.
E
2
1005 1061
Security Switch Off
operation and path
adding operation cannot be
performed simultaneously.
Check the current
configuration and then
make settings again.
First, add paths, then click
Apply. Next, turn off the
security switch, then click
Apply.
E
6
1005 1063
The specified WWN is
already in use. Specify
another
WWN.
Correct the specified
contents, and request the
setting o f the configuration
information again.
E
6
108
HP
StorageWorks XP Remote Web Console for Storage System Messages and Error Codes