HP StorageWorks XP24000/XP20000 for FlashCopy Mirroring Software User Guide (T5240-96012, May 2011)

Table 62 Parameters for the ANTRQST Macro Command in Version 2 (continued)
DescriptionValueParameterCommand
Specifies the device number
(device address) of the
T-VOL on which you want to
perform the FCWITHDRAW
command. To specify this
number, use the TDEVN
parameter. YES is the default
setting.
YESTGTUCB
Specifies the DKC device
number (LDEV number) of the
T-VOL on which you want to
perform the FCWITHDRAW
command. To specify this
number, use the TGTSERIAL,
TGTLSS, and TGTDVC
parameters instead of
TDEVN.
NO
Specifies the DKC device
number of the T-VOL on
which you want to perform
the FCWITHDRAW command.
Use this parameter when the
TGTUCB parameter is NO.
Serial numberTGTSERIAL
Specifies the LSS of the
T-VOL on which you want to
perform the FCWITHDRAW
command. Use this
parameter when the
TGTUCB parameter is NO.
LSSTGTLSS
Specifies the CCA of the
T-VOL on which you want to
perform the FCWITHDRAW
command. Use this
parameter when the
TGTUCB parameter is NO.
CCATGTDVC
Viewing Information for a Version 2 Relationship
To see the status of Version 2 relationships, use the PPRC TSO FCQUERY,ICKDSF, or ANTRQST
Macro command.
Viewing Relationship Status of Version 2 Using the TSO Command
“Parameters for the FCQUERY Command (Version 2)” (page 128) describes the parameters you can
use with the FCQUERY command.
Viewing Information for a Version 2 Relationship 127