HP StorageWorks XP24000/XP20000 for FlashCopy Mirroring Software User Guide (T5240-96012, May 2011)

Table 58 Results from FCWITHDR Command (continued)
ResultsParameterSetting
The relationships established with the
specified copy target extents on the
volume specified by SDEVN are
withdrawn.
DDSW parameter set to YESUnspecified
The command will do nothing and end
normally.
Without any relevant relationships to
withdraw
Unspecified
The FCWITHDR command will do
nothing and end normally.
When the existing relationships do not
fall within the range specified by the
XTNTLST parameter
Unspecified
There are several effective combination patterns of the parameters of the FCWITHDR command.
All combinations, other than those listed in “Combinations of Parameters for the FCWITHDR
Command (Version 2)” (page 111) will result in rejection of this command. “Combinations of
Parameters for the FCWITHDR Command (Version 2)” (page 111) describes the parameters of the
FCWITHDR command and the applicable combinations.
Table 59 Combinations of Parameters for the FCWITHDR Command (Version 2)
ParametersCombination
ACTIONXTNTLSTDDSWDEVNTDEVNSDEVN
TargetSource
Not specifiedNot
specified
Not specifiedNONot specifiedSpecifiedNot specified“Case 1:
TDEVN
Specified,
DDSW =
NO”
(page 112)
Not specifiedSpecifiedSpecifiedNONot specifiedSpecifiedNot specified“Case 2:
TDEVN
Specified,
DDSW =
NO,
XTNTLST
Parameter
Specified”
(page 113)
Not specifiedNot
specified
Not specifiedNONot specifiedSpecifiedSpecified“Case 3:
SDEVN and
TDEVN
Specified,
DDSW =
NO”
(page 115)
Not specifiedSpecifiedSpecifiedNONot specifiedSpecifiedSpecified“Case 4 (a,
b): SDEVN
and TDEVN
Specified,
DDSW =
NO,
XTNTLST
Parameter
Specified”
(page 116)
Releasing a Version 2 Relationship 111