HP StorageWorks XP24000/XP20000 for FlashCopy Mirroring Software User Guide (T5240-96012, May 2011)

Table 53 ANTRQST Macro Command Parameters (Version 2) (continued)
DescriptionValueParameterCommand
Establish the relationship
without using the Preserve
Mirror FlashCopy function.
If PRESMIR is not specified,
NO is set by default.
NOPRESMIR
Establish the relationship
using the Preserve Mirror
FlashCopy function. If the
relationship cannot be
established, the command is
rejected.
TGTPPRIM=YES must be
specified at the same time.
REQ
Establish the relationship
using the Preserve Mirror
FlashCopy function. If the
relationship cannot be
established, the copy
operation is executed using
the existing
FlashCopy-to-PPRC Primary
Volume function.
TGTPPRIM=YES must be
specified at the same time.
PREF
Specifies the serial number
of the storage system
containing the T-VOL on
which you want to perform
the FCESTABLISH
command.
Use this parameter when the
TGTUCB parameter is NO
or the REMOTE parameter
is YES.
Serial number of the storage
system containing the T-VOL
TGTSERIALREQUEST=FCESTABLISH
Specifies the CU number of
the T-VOL on which you
want to perform the
FCESTABLISH command.
Use this parameter when the
TGTUCB parameter is NO
or the REMOTE parameter
is YES.
T-VOL CU numberTGTLSS
Specifies the LDEV number
of the T-VOL on which you
want to perform the
FCESTABLISH command.
Use this parameter when the
TGTUCB parameter is NO,
or the REMOTE parameter
is YES.
T-VOL LDEV numberTGTDVC
Establishing Version 2 Relationships 101