HP StorageWorks XP24000/XP20000 Disk Array Site Preparation Guide (AE002-96055, September 2010)

TIP:
XP components are installed without sliding rails in the XP20000 rack assembly, so the rack does not
require stabilizers. If you install other equipment in the rack, you must consider adding stabilizers.
For information about stabilizers, ballasts, tie-down option kits and other options for the HP 10000
model 10642 G2 rack, see the rack options website:
http://www.hp.com/products/rackoptions
Dimensions
Use the packaged values when determining delivery space requirements and unpackaged values for
space planning.
Table 1 XP24000 dimensions
XP24000 DKC dimensions
Dimensions
DKC packagedDKC unpackaged
incmincm
37.49530.878.2Width
43.711136.592.5Depth
82.320975.6192Height
XP24000 DKU dimensions
DKU packagedDKU unpackaged
incmincm
37.49525.665Width
43.711136.4292.5Depth
82.320975.6192Height
NOTE:
DKU unpackaged width includes two side panels each 1.6 cm (0.63 in.) wide.
Table 2 XP20000 dimensions
XP20000 dimensions
incm
23.860.43Width with side panels
40101.5Depth front to rear door
78.9200.35Height
Site requirements for the HP Disk Arrays14