HP StorageWorks XP24000/XP20000 Audit Log User and Reference Guide (AE131-96013, September 2007)

Example 2 (The case of Synchro. Infor.)
user-name,xx,YYYY/MM/DD,HH:MM:SS:xxx, 00:00,[Install],Set Subsystem Time,Synchro. Infor.,
Normal end,,,Seq.=xxxxx
+{Use Synchro.,SNTP IP,SNTP Port,Time Zone,Check Time}={Valid,(123.456.789.123),100,
Tokyo Standard Time,23}
[Install]
Install function
Set Subsystem Time
Set Subsystem Time operation
TOD Change and Synchro. Infor
TOD Change is the selected parameter for example 1, and Synchro. Infor is the selected parameter
for example 2. This operation uses the following parameters, as shown in the following table.
Table 80 Parameters: Set Subsystem Time Operation
DescriptionParameter
The date and the time.TOD Change
The setting of time correction function.Synchro. Infor.
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in the following table.
Table 81 Detailed Info: Set Subsystem Time Operation
DescriptionItem
Indicates the date and the time in the format of YYYY/MM/DD HH:mm:SS .(YYYY: year,
MM: month, DD: date, HH: hour, mm: minute, SS: second).
Time
Indicates whether the time correction function is valid or invalid.Use Synchro.
Valid: Enable, Invalid: Disable
The IP address of SNTP server.SNTP IP
The port used by SNTP server.SNTP Port
The time zone.Time Zone
The time when the time correction function is executed. Only HH (Hour: 00 to 23) is
indicated for the execution time.
Check Time
XP24000/XP20000 Audit Log User and Reference Guide 113