HP StorageWorks XP24000/XP20000 Audit Log Reference Guide (AE131-96085, May 2011)

15 Data Retention Utility Function
Attribute Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Data Ret],Attribute,,Normal end,,,Seq.=xxxxx
+{LDKC:CU:LDEV,Attribute,RT,Result}=[{0x00:0x00:0x01,0x80,100,Normal end},
{0x00:0x00:0x02,0x82,Unlimited,Error(9605-8122)},{0x00:0x00:0x03,0x81,200,
Normal end},
{0x00:0x00:0x03,0x81,xxxx,Normal end}],Num. of LDEVs=XXX
[Data Ret]
Data Retention Utility function
Attribute
Attribute operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 73 (page 85).
Table 73 Attribute Operation
DescriptionItem
The LDKC, CU, and LDEV numbers of the logical volume where the attribute is set.LDKC:CU:LDEV
The set attribute in hexadecimal. Each bit (0-7) of 1 byte corresponds to the setting item.
1 is assigned to each bit when the setting is enabled and 0 (zero) is assigned to each
bit when the setting is disabled. Each bit represents the following attributes:
Bit 0: Mounting of LDEV (fixed to 1)
Bit 1: Setting of S-VOL Disable
Bit 2: Setting of Zero Read Cap mode
Bit 3: Setting of Invisible mode
Bit 4: Setting of reserve
Bit 5: Fixed to 0 (zero)
1
Bit 6: Setting of Read Only attribute
1
Bit 7: Setting of Protect attribute
1
When 0x88 is output to the attribute, for example, Read/Write attribute is set to the
logical volume to show that the reserve setting has been enabled.
A hyphen (-) is output when setting is not changed.
Attribute
The number of days set in Retention Term.
A hyphen (-) is output when setting is not changed.
RT
The result of operation.
Normal end: Normal end, Error(xxxx-yyyyy): Abnormal end
xxxx: Part code, yyyyy: Error code
Result
The number of the logical volumes where the attribute has been set.Num. of LDEVs
1 When bit 5, 6, and 7 are all 0 (zero), Read/Write has been set.
Expiration-Lock Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Data Ret],Expiration-Lock,SLPR#xx:Enable,Normal end,,,Seq.=xxxxx
[Data Ret]
Attribute Operation 85