HP StorageWorks XP24000/XP20000 Audit Log Reference Guide (AE131-96085, May 2011)

Table 284 Install CV Operation (continued)
DescriptionItem
Indicates system disk status
Enable: Enabled, Disable: Disabled
System Disk
The number of LDEVsNum. of LDEVs
Make Volume Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[VLL],Make Volume,,Normal end,,,Seq.=xxxxxx
+[PG,LDKC:CU:LDEV,Emulation,Size,Unit,System Disk]=[{X-X-(X),0xXX:0xXX:0xXX,OPEN-V,
XXXXXXXXXXXXXXXX,KB,Disable },
{X-X-(X),0xXX:0xXX:0xXX,OPEN-V,XXXXXXXXXXXXXXXX,KB,Disable}],Num. of LDEVs=2
[VLL]
Virtual LVI / Virtual LUN function
Make Volume
Make Volume operation
No parameter
No parameter is selected in the above example. This operation uses the following parameters, as
shown in Table 285 (page 230).
Table 285 Parameters for Make Volume Operation
DescriptionParameter
Unformatted Make Volume. The logged information indicates that the volume was created.Non Format
Quick Formatted Make Volume. The logged information indicates that the formatting was
only requested, but not finished.
Quick Format
NOTE: No parameters are selected for any case other than those described in this table. The logged information
indicates that the formatting was only requested, but not finished.
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 286 (page 230).
Table 286 Make Volume Operation
DescriptionItem
The parity group number
The parity group number whose first letter is E indicates that an external volume is present
in the parity group.
PG
The LDKC, CU, and LDEV numbersLDKC:CU:LDEV
The emulation typeEmulation
The user-specified capacitySize
230 VLL Function