HP StorageWorks XP24000/XP20000 Audit Log Reference Guide (AE131-96085, May 2011)

39 VLL Function
Install CV Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[VLL],Install CV,,Normal end,,,Seq.=xxxxxx
+{PG,LDKC:CU:LDEV,Start LBA,Emulation,Size,Unit,System Disk }=
[{XX-XX-(X),0xXX:0xXX:0xXX, XXXXXXXX,OPEN-V,XXXXXXXX,KB,Disable},
{X-X-(X),0xXX:0xXX:0xXX,XXXXXXXX,OPEN-V,XXXXXXXX,KB,Disable}],Num. of LDEVs=2
[VLL]
Virtual LVI / Virtual LUN function
Install CV
Install Customized Volume (CV) operation
No parameter
No parameter is selected in the above example. This operation uses the following parameters, as
shown in Table 283 (page 229).
Table 283 Parameters for Install CV Operation
DescriptionParameter
Unformatted Install CV. The logged information indicates that the volume was created.Non Format
Quick Formatted Install CV. The logged information indicates that the formatting was only
requested, but not finished.
Quick Format
NOTE: No parameters are selected for any case other than those described in this table. The logged information
indicates that the formatting was only requested, but not finished.
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 284 (page 229).
Table 284 Install CV Operation
DescriptionItem
The parity group number
The parity group number whose first letter is E indicates that an external volume is present
in the parity group.
PG
The LDKC, CU, and LDEV numbersLDKC:CU:LDEV
The start LBA
A hyphen (-) is output when not specified.
Start LBA
The emulation typeEmulation
The user-specified capacitySize
The unit of the CV capacity. The output unit is different according to the setting.
KB: For open-system volume
Cyl: For mainframe-system volume
LBA: When LBA is specified
Unit
Install CV Operation 229