HP StorageWorks XP24000/XP20000 Audit Log Reference Guide (AE131-96085, May 2011)

The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 256 (page 209).
Table 256 Add Pair Operation
DescriptionItem
The LDKC, CU, and LDEV numbers of the volume specified to the main volume when
the pair is created
M-VOL
(LDKC:CU:LDEV)
The LDEV number of the volume specified to the remote volume when the pair is createdR-VOL (LDEV)
The serial number of the deviceS/N
The LDKC number of the paired LDKCLDKC
Indicates SSIDSSID
The controller ID.Controller ID
The update copy mode set; Sync: Synchronous mode, Async: Asynchronous modeType
The initial copy mode set; Entire: Copy all, None: Do not copyInitial Copy
The fence level set (the condition that MCU rejects the write operation to the main
volume)
Never: No condition, Data: S-VOL data, Status: S-VOL status
Fence Level
The initial copy speed set (the number of tracks you can copy at a time)Copy Pace
The priority of the initial copy operation set (scheduling order)Priority
The unit of the differential management set: Auto, Cylinder, TrackDiff
Indicates whether the setting to copy the CFW data to the remote volume is enabled
or not. Only M-VOL: Copy to main volume only is enabled.
Copy To R-VOL: Copy to main and remote volume is enabled
CFW
Indicates whether DFW use to the remote volume is set or not. This value is output only
when the synchronous pair is created. When the asynchronous pair is created, a hyphen
(-) is output.
Not required: DFW not required, Required: DFW required
DFW
Indicates whether or not the host I/O time stamp is transferred to R-VOL when the pair
is created. This value is output only when the synchronous pair is created. When the
asynchronous pair is created, a hyphen (-) is output.
Enable: transferred, Disable: not transferred
TS
The consistency group number of the consistency group (CT group) that the created
pair belongs to. This value is output when the asynchronous pair is created only.
CTG
The error level set (handling if trouble occurs). This value is output when the asynchronous
pair is created only.
Volume: Volume (suspended by appropriate pair); Group: Group (suspended by
consistency group)
Error Level
The result of operation
Normal end: Normal end, Error(xxxx-yyyyy): Abnormal end
xxxx: Part code, yyyyy: Error code
Result
The number of created pairsNum. of Pairs
Add Pair Operation 209