HP StorageWorks XP24000/XP20000 Audit Log Reference Guide (AE131-96085, May 2011)

user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[RCU],Add RCU,,Normal end,,,Seq.=xxxxx
+{S/N,MCU LDKC,MCU,RCU LDKC,RCU,SSID,Controller ID,Min.Path,MIH Time(s),
Round Trip Time(ms),Incident,FREEZE}={99999,0x00,0x3F,0x00,0x7F,0x0004,4,08,015,001,
only to RCU host,Disable}
++{MCU Port,RCU Port}=[{1E,3E},{5E,7E},{1F,3F},{5F,7F},{1G,3G},{5G,7G},{1H,3H},{5H,7H}],
Num of Port Pairs=8
[RCU]
Remote Control Unit function
Add RCU
Add Remote Control Unit operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 238 (page 194).
Table 238 Add RCU Operation
DescriptionItem
Indicates a serial number of the registered RCU device.S/N
The LDKC number of the connected LDKC.MCU LDKC
The LDKC number of the paired LDKC.RCU LDKC
The path group ID of the registered RCU. When the path group ID is default setting,
Default is output.
Path Gr.ID
The controller ID of the registered RCU device.Controller ID
The CU number of the connected CU.MCU
The CU number of the paired CU.RCU
The SSID of the registered RCU.SSID
The port number of MCU.MCU Port
The port number of the registered RCU.RCU Port
The number of set minimum paths.Min.Path
The value of set RIO MIH (Remote I/O Missing Interrupt Handler) timer (wait time until
data copy from MCU to RCU is completed). The unit is second.
MIH Time(s)
The round-trip response time set (delay time for round-trip remote I/O). The unit is
millisecond. This value is output when HP XP Continuous Access Software or TrueCopy
for Mainframe is used.
Round Trip Time
(ms)
The set incident of the RCU. This value is output only when TrueCopy for Mainframe is
used.
only to RCU host: RCU host only, to any host.
Incident
Indicates whether CGROUP (FREEZE/RUN) PPRC TSO command support is enabled or
disabled. This value is output only when TrueCopy for Mainframe is used.
Enable or Disable is output.
FREEZE
The number of port pairs set.Num of Port Pairs
Change RCU Option Operation
Example 1 (CU Free is used)
194 RCU Function