HP StorageWorks XP24000 for FlashCopy Mirroring Software User's Guide (T5240-96001, June 2007)

FCWITHDR DEVN(
X'4202') ACTION(THAW)
Figure 62 Exampl
e:
FCWITHDR Command Description (DE VN Specified, ACTION =
THAW) (Ca s e 7)
Since no relationship is withdrawn by performing the above-mentioned command, there will be no
change in the number of relationships after using the command.
Note that even if you do not issue this command, the write operation to volumes may be resumed
automaticall
y
if the state-change-pending time elapses. For information about the state-change-pending
time, see “Establishing Version 2 Relationships while Suspending Write Operations to S-VOLs”onpage82.
Viewing Information for Version 2 Relationships
This section describes how to see the status of Version 2 relationships by using commands or Remote
Web Console.
Viewing Rela
tionship Status of Version 2 Using FCQUERY
To see the sta
tus of Version 2 relationships, use the PPRC TSO’s FCQUERY command. The following table
shows the parameters you can use with the FCQUERY command.
Table40Parameters for theFCQUERY Command (Version2)
Parameter
Value
Description
DEVN
Device number.
Spec ify the
number (device address) of the Version 2 volume for whic h
you want to s
ee the
status.
The FCQUERY
command can
be used to display information, including the attributes set to the devices
specified by
DEVN, and the number of Version 2 relationships established with the specified devices.
The figure below shows an example of the FCQUERY command. This example requests the information
on thedevicenumbered4202tobedisplayed.
FCQUERY DVEN(X'4202')
Figure 63 Example of t he FCQUERY Command Description
The figure below shows the information displayed as a result of executing the command described above.
The displayed information is explained in Table 41 on page 97.
96
Performing Version 2 Operations