HP StorageWorks XP24000 for FlashCopy Mirroring Software User's Guide (T5240-96001, June 2007)

4. Select and right-click the CU for which you want to change the state-change-pending time.
Apop-up menu isdisplayed.
Note: You may select multiple CUs at a time. If you select multiple CUs, you a re to set the same
state-change-pending time to all selected CUs.
5. Select the SCP Time Setting command from the pop-up menu.
The Set SCP Time dialog box (Figure 44 on page 83) is displayed.
6. Enter the state-change-pending time you want to set.
7. Click OK.
The Set SCP Time dialog box closes and the changed state-change-pending time is displayed
on the
FCv2 window.
8. To change the state-change-pending time for other CUs, repeat steps 2 through 7.
9. Click Apply.
Aconfirmation message is displayed and asks if it is OK to apply the changes of
state-change-pending tim e to the subsystem.
10. Click OK.
The setting in the Set SCP Time dialog box is applied to the subsystem and the
state-change-pending time changes.
Figure 44 Set SCP Time Dialog Box
The items displayed in the Set SCP Time dialog box are as follows:
• The SCP Time(sec.) text box specifies the state-change-pending time in seconds (0 to 600
seconds). The text box displays the state-change-pending time that is set for the CU selected in the
FCv2 window by default. If multiple CUs are selected and the state-change-pending time that is
set for each CU is different, the text box will be blank by default.
• The OK button closes the SCP Time dialog box and displays the changed state-change-pending
time in the FCv2 window. Note that if the SCP Time(sec.) text box is blank, the setting in the SCP
Time dialog box is invalid.
• The Cancel button cancels the setting in the SCP Time dialog box and closes the dialog box.
Releasing a Version 2 Relationship Using FCWITHDR
The FCWITHDR command can be used to withdraw relationships established for copy operations set
either i
n
COPY or NOCOPY mode.
Caution: If you use the FCWITHDR command only one time when deleting a large number of
relationships, a timeout may occur on the host. Therefore, use the FCWITHDR command more than one
time when deleting a large number of relationships. Also, after you execute the F CWITHDR command
one
time, wait for a while before you execute the com mand again. For example, if you execute the
FCWITHDR comm and one time when deleting more than 700 relationships, wait for approximately 5
seconds before you execute the comma nd again.
The following table shows the parameters you can use with the FCWITHDR command when you release
Versi
on 2
relationships.
XP24000 for FlashCopy Mirroring Software User's Guide
83