HP StorageWorks XP24000 Continuous Access Journal Software User and Reference Guide, v01 (T5278-96001, June 2007)

Path Status
Description Corrective Action
Port number
invalid
The specified port number
is invalid. The cab le is not
connected to the specified
port.
Delete the failed path. Check the specified port
number or the cab le connection and then retry.
Communication
err or
Atimeout erro
rhas occurred
in the
fibre pat
h
between
the local and
remote storage
systems.
Delete the failed path and retry.
Pair-Port Number
Mismatch
The specified port in the
remote storage system is
physically disconnected from
the loca l storage system.
Make sure th at you specified the correct remote
storage system por t. Correct the port number if
necessary.
Make sure that the local and the remote storage
systems are connected via cables to each other. If
the storage systems are not connected via cables,
connect them via cables and then retry the operation.
Make sure that the topology settings for ports on the
local
and remote storage systems are correct.
Pair-Port Type
Mismatch
The specified remote storage
system port is not configured
as an
RCU target port.
Make sure that the remote storage system port is
configured as an RCU target port.
Communication
Failed
The loc al storage system
connected to the remote
storage system successfully,
but a logical communications
timeout
occurred.
Make sure that the remote storage system port and
network relay devices (for example, cables and
switches) are properly configured and functioning.
Logical Blockade
A failure occurs at a local
storage system port.
Repair the por t status on the local storage system.
A failure occurs at a remote
storage system port.
Repair the port status on the remote storage system.
After that, delete the path by using the Delete Path or
Delete
DKC command, and then add the path and
the remote storage system ag ain by using the Add
Path or Add DKC command.
Afai
lure occurs in the path
rela
yequipment.
Repair the path relay equipment. After that, delete
the path by using the Delete Path or Delete DKC
command, and then add the path and the remote
storage system again by using the Add Path or Add
DKC command.
Theconnectioncableis
physically broken.
Replace the broken cable. After that, delete the path
by
using the Delete Path or Delete DKC command,
and
then add the path and the remote storage system
again by using the Add Path or Add DKC command.
Program Error
Program error is detected.
Delete the path by using the Delete Path or Delete
DKC command, and then add the path and the
remote storage system again by using the Add Path
or
Add DKC command.
<blank> This path was not established.
D
elete the failed path. You may need to change the
m
inimum
paths setting or delete the remote storage
system in order to delete the path. After the deletion
finishes, add the path and the remote storage system
by
using the Add Path or Add DKC command.
154
Troubleshooting