HP StorageWorks XP24000 Continuous Access Journal Software User and Reference Guide, v01 (T5278-96001, June 2007)

Figure 63
Detailed Informa tion Window
The Detai
led
Information window displays the following:
• Status: Indicates the status of the pair. If the pair is split (or suspended) , Status also displays the
suspend type. If the pair is waiting for initial copy, Status also displays the word (Queuing).
• Sync.:I
f
the volume in the local storage system is a primary data volume, Sync. displays progress
of an
in
itial copy operation.
If the
volume in the loc al storage system is a secondary data volume, Sync. displays information
in the
following ways:
• If the volume pair is not split, Sync. displays nothing.
•If the v
olume pair is split and, therefore, is in PSUS or PSUE status, Sync. usually displays
the
synchronization rate (that is, concordance rate) between the sec ondary data volume
before it became split and the secondary data volume after it became split. For example, the
synch
ronization rate (that is, concordance rate) is 100 percent if the contents of the secondary
data volume are the same before and af ter the volume pair became split.
Caution: If a failure in the initial copy operation causes the volume pair to be split, Sync.
displ
ays nothing. If a failure occurs in the initial copy operation, the Detailed Information
wind
ow
(Figure 63 on page 132) displays the phrase Initial co py failed.
This column is blank when the volume in the local storage system is neither a primary data
volume nor a secondary data volume.
• P-VO
L: Indicates the primary data volume.
The first line displays the port number, the G I D, the LUN, and the LD KC:CU:LDEV (the number of
the
LDKC, the number of the CU, and the number of the LDEV) of the primary data volume. The
GID
i
s a
group number for a host group. If the primary data volume exists in the local storage
syst
em, the first line also displays the CLPR number and the CLPR name. If the primary data
volume is a LUSE volume, the LUN is the LDEV number of the top LDEV (that is, the smallest LDEV
number in the group of LDEVs that are combined as a LUSE volume).
The s
econd
line displays the device emulation type.
Thethird line displays thevolumecapacity.
132
Performing Continuous Access Journal Pair Operations