HP StorageWorks XP24000 Continuous Access Journal Software User and Reference Guide, v01 (T5278-96001, June 2007)

14. Select Apply to start pair creation and the initial co py o peration.

Note

: If an error occurs, the right-most column of the Preview list displays the error code. To

view detailed information about the error, right-click the error code and then select Error Detail.

An error message appears and gives you detailed information about the error.

15. In thelistofthe Pair Operations window, verify that the status of the pair is correct.

16. To monitor the progress of the paircreate operation(s), click File, Refresh on the m enu bar of the

Remote We b Console main window to update the information in the list, or use the D etailed

Information window (see Figure 63 on page 132) to monitor the detailed status of each pair.

Figure 6

Pairc reate Window

The Paircreate window displays the following:

• P-VOL: Indicates a primary data volume. The numbers indicates the port number, the GID, and

theLUN of theprimary datavolume. Thenumbers in parenthesesare theLDKCnumber, theCU

number and the LDEV number. The GID is a group number for a host group.

Notes

• P-VOL displays only one primary data volume even when two or more p rimar y data volumes

are selected in the Pair O p eration window. P-VOL only displays the primary data volume that

has the smallest LUN (LU number).

• If a volume is an external volume, the # symbol appears af ter the LDEV number. For detailed

information about external volumes, see the HP StorageWorks XP24000 External Storage

Software User’s Guide.

• S-VOL: Allows you to select a secondary data volume. When specifying a secondary data

volume, you must use the three drop-down lists to select a port, a GID, and a LUN of the

secondary data volume . The GID is a group number for a host group.

Note

: You can select only one secondar y data volume even when two or more primary data

volumes are selected in the Pair O peration window. Continuous Access Journal automatically

speciﬁes the other secondary data volumes. For detailed information, see the explanation about

the

Select Other S-VOL(s) option later in this section.

Note

: If you selected more than one primary data volume, select the secondary data volume for

the

primary data volume being displayed. The secondary data volumes for the rest of the primary

XP24000 Continuous Access Journal Software User a nd Reference Guide

129