HP StorageWorks XP24000 Continuous Access Journal Software User and Reference Guide, v01 (T5278-96001, June 2007)

Figure 5
0Add DKCWindow
The Add DKC window displays the following:
• S/N: Allows you to enter the fi ve-digit serial number of the remote storage system.
• LDKC: Allows you to enter the LDKC number of the remote storage system. Enter 00 when the
remote storage system is an HP XP12000 Disk Array.
Note : LDKC#01 cannot be used in this version.
• Controller I D: Allows you to enter the controller ID (model nam e that indicates the model) of
the
remote storage system.
Note : The controller ID for a storage system is 5(XP24).
• Path Gr. ID: Allows you to enter the path group I D. Path group IDs are used for identifying g roups
of
logical paths. One path group can contain up to eight logical paths.
Path group IDs are within the range of 0-FF (hexadecimal). If you select the Default check box, the
default path group ID will be set.
Note : In the current version, you cannot enter path group IDs. Also, you cannot clear the Default
check box. The number of path groups per one remote storage system is always 1.
• M-R Path: Allows you to specify logical paths from initiator ports on the local storage system to
RCU target ports on the remote storage system.
• Port: Displays a list of initiator por ts on the loca l storage system. Select an initiator port
from this drop-down list.
• Pair-Port: D isplays a list of all ports on the remote storage system. Select an RCU target port
on the remote storage system from this drop-down list.
Note : When specifying a port, you c a n use the keyboard to enter the por t number. When you
enter the port number, you ca n abbreviate the port number to two characters. For example, you
can
enter 1A instead of CL1-A. You can use uppercase and lowercase letters.
• Option: Opens the DKC Option window (see
“Changing Options for Logical Paths and Storage Systems” on page 101).
100
Configuring Storage Systems and Logical Paths