SVS 200 SNMP Agent Reference Guide (AE002-96035, October 2007)

3. Select and then right-click the community name that you want to change in Community & Trap.

The Change Community popup menu displays (see Figure 10 on page 21).

4. Select Change Community.TheChange Community dialog box displays (see

Figure 11 on page 21).

5. In the Community text box, overwrite the old community name with a new community name. You

can use up to 180 alphanumeric characters, except for ", \, ;, :, ,, *, ?, <, >, |, /, ^, &,and%.

You can also use spaces, except at the beginning or the end of the name.

6. Select OK. The changed community name displays in Community & Trap, but the changes are

not yet implemented in the subsystem.

7. Select Apply.SelectOK or Cancel.

Figure 10 Change Community Pop-Up Menu

Figure 1

1 Change Community dialog box

Adding Community IP Addresses

To add a community IP address:

1. Log on to Remote Web Console.ClickGo – Environmental Settings – SNMP Information in the

menu bar of Remote Web Console Main window. The SNMP Information window is displayed

(see Figure 4 on page 15).

2. Select and right-click the desired community to display the Add Community pop-up menu (see

Figure 12 on page 22).

3. Select Add IP Address.TheAdd IP Address dialog box displays (see Figure 13 on page 22).

4. In IP Address, enter a new IP address or select an existing IP address.

XP12000/XP10000/SVS 200 SNMP Agent Reference Guide