SVS 200 SNMP Agent Reference Guide (AE002-96035, October 2007)

• Set: Adds new IP addresses to the IP Address list box.

• Community & Trap allows you to add, delete, or change SNMP trap information. The registered

IP address is the trap destination for the speciﬁed community.

• Eachcommunitycanhavemorethanonedeﬁned IP address (sees

“Adding a Community Name” on page 19 and “Adding Community IP Addresses”onpage21).

• You can register up to 32 community names and up to 32 IP addresses per community name.

• You can use up to 180 alphanumeric characters for a community name. You cannot use the

following: ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, %, and a space before or after the community

name.

• System Group allows you to add, delete or change SNMP system group information. If system

group information has already been registered, the registered information displays. To register the

system group information, the Extension SNMP check box must be selected. When you register

system group information, select Apply.Systemgroupinformationisasfollows:

• Name: Connected subsystem device name. Remote Web Console users can change the

device name. You can use up to 180 alphanumeric characters for a device name. You cannot

use the following: ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, %, . You can use a space in the middle of

the device name, but not before and after and a space before or after the device name.

Note:

The device name is required to use SNMP Agent. Make sure to document the device name,

because settings will be cleared when SVP is replaced.

• Contact: Contact information such as personnel and telephone numbers where you can

inquire about the connected subsystem. Remote Web Console users can change contact

information in Modify mode. Enter contact information using up to 180 alphanumeric

characters (ASCII codes), except for some symbols, such as ", \, ;, :, ,, *, ?, <, >, |, /, ^, &,

and %. You can also use a space, except before and after contact information.

Note:

AcontactnameisrequiredtouseSNMPAgent.Makesuretodocumentthecontactname,

because settings will be cleared when SVP is replaced.

• Location: Location of connected subsystem. Remote Web Console users can change

device locations with the modify mode. You must enter a device location using up to 180

alphanumeric characters (ASCII codes). You can use a space, except for before and after the

location. You cannot use some symbols, such as ", \, ;, :, ,, *, ?, <, >, |, /, ^, &,and%.

Note:

The device location is required to use SNMP Agent. Make sure to document the device

location, because the settings will be cleared when SVP is replaced.

• Apply implements settings made on this window.

• Cancel cancels settings made on this window.

Using the SNMP GUI