HP StorageWorks XP Remote Web Console User Guide: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (T1714-96031, June 2010)

NOTE:
When you want to configure the setting of a remote command device, add "#$" at the beginning of
the row. If you do not add "#$", an error occurs.
Table 25 lists the values available for the [LDEV] tag.
Table 25 Available Configuration Values for the [LDEV] Tag
Available ValueItemColumn
00 - 3F. Set with hexadecimal numbers in one or two digits.CU #
1st, 11th (In-
dex)
00 - FF. Set with hexadecimal numbers in one or two digits.LDEV #
2nd, 12th
(Index)
Enable or Disable (The default when the spreadsheet is exported)
ON or OFF are also available as the set value when you write the
spreadsheet.
Cmd. Dev (Com-
mand Device)
3rd, 13th
Enable or Disable (The default when the spreadsheet is exported)
ON or OFF are also available as the set value when you write the
spreadsheet.
Cmd. Sec (Com-
mand Device Secur-
ity)
4th, 14th
Blank
5th, 6th,
15th, 16th
Configuration File Loader Operations
Configuration File Loader Pane
The Configuration File Loader panel (Figure 111) opens when you start Configuration File Loader.
From this panel, you can export a spreadsheet file with the current configuration information, and
import a file with the new configuration. You can also see the status and the error information for the
imported file before you apply the changes.
XP Remote Web Console User Guide 159