HP StorageWorks XP Remote Web Console User Guide: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (T1714-96031, June 2010)

• WWN settings allow you to add, delete or change the WWN information. See “Setting the WWN
Information” on page 157.
• LU path settings allow you to add, delete, or change LU paths. See “Setting the LU
Path” on page 157.
• Command Device settings and set or release the command device and command device security.
See “Configuring the Command Devices” on page 158.
Column Format
The LUN Manager spreadsheet allows you to write the settings for CHA mode, port, host group,
WWN, path definition, and command devices. The format of the LUN Manager spreadsheet is as
follows:
• 1st column to 6th column: Current settings area
• 7th column to 10th column: Blank columns
• 11th column to 16th column: New settings area
The number of columns used depends on the function tag. If a particular function tag requires less
than six columns, the unused columns are left blank.
Table 18 describes the format of the LUN Manager spreadsheet.
Table 18 LUN Manager Spreadsheet Format
Function Tag
Column
[LDEV][LUN][WWN][HostGroup][Port][CHA]
CUPortPortPortPortCHA1st
LDEVGroup IDGroup IDGroup IDSecurity SwitchPCB Mode2nd
Command
Device
LUNWWNNameAL-PABlank3rd
Command
Device Security
CUNameHost modeFabricBlank4th
BlankLDEVBlank
Host mode op-
tion
ConnectionBlank5th
BlankBlankBlankChannel speedBlank6th
Blank7th
Blank8th
Blank9th
Blank10th
CUPortPortPortPortCHA11th
LDEVGroup IDGroup IDGroup IDSecurity SwitchPCB Mode12th
Command
Device
LUNWWNNameAL-PABlank13th
XP Remote Web Console User Guide 151