HP StorageWorks XP Remote Web Console User Guide: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (T1714-96031, June 2010)

Figure 100 Change Community Pop-Up Menu
.
Figure 101 Change Community Pane
.
Adding Community IP Addresses
To add a community IP address:
1.
Log on to open the XP Remote Web Console main panel and then click Install ( ). Click the
SNMP IP Security tab to display the SNMP IP Security panel (Figure 94).
2. Select and right-click the desired community to display the Add Community popup menu (see
Figure 102).
3. Select the Add IP Address command. The Add IP Address panel is displayed (see Figure 103).
4. In the IP Address box, enter a new IP address or select the existing IP address.
5. Click OK. The new IP address is displayed in the Community & Trap box, but the change is not
yet implemented to the array.
6. To apply the changes to the array, click Apply. Click OK. To cancel the changes, click Cancel.
XP Remote Web Console User Guide 139