HP StorageWorks XP Remote Web Console user guide for the XP1024/XP128 (December 2005)

Setting SNMP Agent Properties 75
4-3-5 Changing a Community Name
To change a community name:
1. Change to Modify mode (see section 2-5 if you need instructions).
2. Click Install (
).
3. Click the SNMP IP Security tab.
4. Select and then right-click the community name that you want to change in Community & Trap. The Change
Community popup menu is displayed (see Figure 4-8).
5. Click the Change Community command. The Change Community pane is displayed (see Figure 4-9).
6. In the Community text box, overwrite the old community name with a new community name (up to 180
alphanumeric characters, excluding ” * $ ^ | < > ? % & \ and space).
7. Click OK. The changed community name is displayed in the Community & Trap box, but the changes are
not yet implemented in the subsystem.
8. If you want to apply the changes to the subsystem, click Apply. Click OK (or Cancel).
Figure 4-8 Change Community Pop-Up Menu
Figure 4-9 Change Community Pane