HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 24 Error Codes — Part Code 0610 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0iIf you have performed the
Disconnect operation, select
[Yes]. If you have not
performed the Disconnect
operation, select [No]. To
cancel the operation, select
[Cancel].
Have you performed the
Disconnect operation?
590140610
0WSelect [OK].The volume is mapped as a
mainframe volume by the
Add LU operation. Format the
volume before using it.
590150610
0iSelect [OK].No emulation type is
selected. Select the emulation
type.
590160610
0iSelect [OK].No LDEV is selected. Select
the LDEV.
590170610
0iSelect [OK].The setting is insufficient for
automatic mapping. Check
the setting, and then retry the
operation.
590200610
0iRetry the operation.The automatic mapping
processing was interrupted.
590210610
0iDecrease the number of
external volumes to be
mapped, and then retry the
operation.
There are not enough logical
volumes to perform the
automatic mapping
operation.
590220610
0iSelect [OK].The Check Paths processing
began. After three minutes,
select the [Refresh] button to
check the path status.
590290610
0WTo continue processing, select
[OK]. To stop processing,
select [Cancel].
The processing of this
command takes some time to
complete. Do you still want
to execute the command?
After you execute the
command, select [Refresh] to
check the progress.
590340610
0WThe number of paths
registered to a port has
reached the maximum.
Select [OK] to continue
processing, or select [Cancel]
to stop processing. When
you select [OK], the
processing continues without
counting the path data
registered after the maximum
is reached.
The number of paths
registered to a port has
reached the maximum.
Select [OK] to continue
processing, or select [Cancel]
to stop processing. When
you select [OK], the
processing continues without
counting the path data
registered after the maximum
is reached.
590370610
0WIf you do not want to write
the cached data to the
volume, select [OK]. To
cancel the operation, select
[Cancel].
Do you want to execute the
Delete LU operation without
writing the cached data to
the volume?
590380610
XP Remote Web Console Error Codes 97