HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 65 Error Codes — Part Code 8105 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
2EShut down the NAS OS, and
then retry.
You cannot delete the
specified system LU because
the system LU is being used
by the NAS package. To
delete the system LU, shut
down the NAS OS.
11888105
6EDelete a file system
configured on the user LU,
and then retry.
Failed to delete the specified
user LU because it is being
used by the NAS package.
To delete the specified user
LU, delete the file system
configured on the LU that is
set by this user LU.
11898105
6ECorrect the settings, and then
retry.
You cannot add paths to
Continuous Access/XP
Business Copy/XP Flex Copy
pair volumes.
11938105
6ECorrect the settings, and then
retry.
Since a path is defined to an
external LU, you cannot set
high-speed mode.
11988105
5EChange the parameter to a
path where the High Speed
mode/MIX mode can be set,
and then retry the operation.
The selection of High Speed
mode/MIX mode is invalid.
The specified port cannot be
changed to High Speed
mode/MIX mode.
12018105
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
High Speed mode/MIX mode
was specified. However,
there are addresses to which
High Speed mode/MIX mode
cannot be set in the Fibre
Addresses of the specified
ports.
12038105
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
High Speed mode/MIX mode
was specified. However,
there are topologies to which
High Speed mode/MIX mode
cannot be set in the
topologies of the specified
ports.
12048105
2EThe port you are trying to set
is for Fibre Continuous
Access. You need to change
the attribute when adding a
path. Attribute (TarGet or
RCU TarGet)
Add path to the initiator port
failed.
13508105
6ECannot set to high-speed
mode because the port
attributes are mixed, or
cannot set to
internal/external mix mode
because the combination of
port attributes is different.
Check the port attributes, and
then retry the operation.
The high-speed or
initiator/external mix mode
cannot be set to the specified
port because of the attribute
of the port.
13518105
326 HP StorageWorks XP Remote Web Console for Storage System Messages and Error Codes