HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 65 Error Codes — Part Code 8105 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
Failed to set the WWN
because the number of
WWNs exceeds the
maximum that can be set in
a port.
11328105
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
Failed to set the host mode
because the number of host
modes exceeds the maximum
that can be set in a port.
11338105
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
Failed to set the path because
the number of paths exceeds
the maximum that can be set
in a port.
11348105
2EWhen PORT information
(Fibre Address/Fibre
Topology/Channel Speed) is
set, multiple change
instructions are set to the
same PORT. The error does
not occur normally because
it is guarded in the screen.
Contact the program maker.
An error occurred. If this
problem persists, call
technical support.
11358105
2EWhen CHIP high-speed mode
is set, multiple change
instructions are set to the
same PORT. The error does
not occur normally because
it is guarded in the screen.
Contact the program maker.
An error occurred. If this
problem persists, call
technical support.
11368105
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
Failed to from a LUSE volume
because the number of LUSE
volumes exceeds the
maximum that can be set in
a disk array subsystem.
11378105
6WRelease the Port Group
setting.
Nothing is set. Create a
setting and then execute it.
11408105
6ECorrect the specified
contents, and request again.
The specified path cannot be
added, because the volume
is used by a Continuous
Access pair.
11818105
0WCorrect the port information
or the PCB mode information.
The port information is
inconsistent with PCB mode
information.
11838105
0WCorrect the port information
or the PCB mode information.
The port information is
inconsistent with PCB mode
information.
11848105
XP Remote Web Console Error Codes 325