HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 65 Error Codes — Part Code 8105 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
Command device security
cannot be set to the specified
volume because the volume
is not a command device.
11238105
2EThe setting method of
command device/command
device security is incorrect.
The following settings are
invalid. *Set command
device + Release command
device security
*Release command device +
Set command device security
It does not occur normally
because it is guarded in the
screen. Contact the program
maker.
An error occurred. If this
problem persists, call
technical support.
The command device setting
and the command device
security setting are incorrect.
You cannot do any of the
following to the same volume:
• Specify the volume as a
command device and
disable command device
security on the volume.
• Specify the volume as a
non-command device and
enable command device
security on the volume.
11248105
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
There are no host groups
where the WWN will be
registered.
11258105
5ECorrect the specified
contents, and request again.
A volume set as a command
device cannot be used as a
component of a LUSE volume.
Select another volume.
11268105
2ECHIP high-speed mode is
specified to unmounted CHIP.
The error does not occur
normally because it is
guarded in the screen.
Contact the program maker.
An error occurred. If this
problem persists, call
technical support.
11278105
2EChannel speed change is
requested, but Fibre PCB
does not support it. The error
does not occur normally
because it is guarded in the
screen. Contact the program
maker.
An error occurred. If this
problem persists, call
technical support.
11288105
6ECorrect the specified
contents, and request again.
The specified name is the
same as the system default
name. Change the name.
11308105
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
Failed to set the host group
because the number of host
groups exceeds the maximum
that can be set in a port.
11318105
324 HP StorageWorks XP Remote Web Console for Storage System Messages and Error Codes