HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 65 Error Codes — Part Code 8105 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
2EThe volume which links as an
expanded LU extend over
CU#. The error does not
occur normally because it is
guarded in the screen.
Contact the program maker.
An error occurred. If this
problem persists, call
technical support.
10118105
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
LU path is set to a volume
which links as an expanded
LU.
10128105
2EThe emulation type of a
volume which links as an
expanded LU is not the same.
The error does not occur
normally because it is
guarded in the screen.
Contact the program maker.
The emulation types of the
volumes combined into a
LUSE volume are not the
same.
10138105
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
LU path is set to the releasing
expanded LU. (You need to
release the expanded LU and
path at the same time.)
10158105
2EThe specified port does not
exist. You have specified a
wrong port number. Or the
specified port type
(exclusively for mainframe)
cannot be processed in this
agent. The error does not
occur normally because it is
guarded in the screen.
Contact the program maker.
An error occurred. If this
problem persists, call
technical support.
10188105
2EHost mode is invalid. (The
specified value is not in the
specification.) The error does
not occur normally because
it is guarded in the screen.
Contact the program maker.
An error occurred. If this
problem persists, call
technical support.
10228105
5WCorrect the specified content,
and issue the request again.
(Currently, Bad Value Send
report in Set Response.)
The specified fiber address is
wrong.
10238105
2EFibre topology information is
invalid. (The specified value
is not in the specification.)
The error does not occur
normally because it is
guarded in the screen.
Contact the program maker.
An error occurred. If this
problem persists, call
technical support.
10248105
XP Remote Web Console Error Codes 321