HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 63 Error Codes — Part Code 7110 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0WWait for a while, and retry
the operation. If the same
error occurs despite retrying,
call technical support.
The settings could not be
applied.
73117110
0WCall technical support.The password could not be
acquired.
73127110
0WCall technical support.Error details not available.73137110
2EIf this problem persists, call
technical support.
An error occurred during
processing. If this problem
persists, call technical
support.
74407110
4ERetry the operation. If you get
the same message again,
reboot the computer. If
necessary, call technical
support.
A time-out error occurred.
Wait for the subsystem to
recover to the normal
condition, and then retry the
operation.
80017110
0iCall technical support.An internal logic
contradiction occurred.
85347110
0ECheck the error code in
Preset Volume list.
Some settings could not be
applied normally. See the
error code.
86587110
0iCheck the contents, and retry.There is no volume.86597110
0iThe operation was ended
normally. Execute the next
operation.
The requested operation has
completed.
90027110
0iAn error occurred during the
indicated operation. See the
error code for each operation
in Preset Volume list.
An error occurred. Check the
error code.
90057110
0iTo cancel, press the OK
button.
Do you want to cancel?91017110
0iSelect [OK] to execute the
operation.
Do you want to apply?91027110
0WTo continue processing, select
[OK]. Otherwise, select
[Cancel].
The option has been
changed. If you continue
processing before applying
the change, the option will
be reset to the current setting.
Do you want to continue
processing?
91087110
2WTo continue processing, select
[OK]. Otherwise, select
[Cancel].
Do you want to execute the
Set Over operation?
91097110
2WTo continue processing, select
[OK]. Otherwise, select
[Cancel].
Do you want to execute the
Initialize operation?
91107110
0iTo continue processing, select
[OK]. To stop processing,
select [Cancel].
Do you want to enable the
setting to expand the number
of relationships?
93777110
XP Remote Web Console Error Codes 315