HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 62 Error Codes — Part Code 7105 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0iSpecify the emulation type of
the supported volume.
The emulation type of the
specified reserved volume is
not supported.
85337105
0iCall technical support.A processor failure was
detected.
85357105
0iCall technical support.A cache failure was detected.85367105
0iCall technical support.The cache capacities do not
match.
85377105
0iCall technical support.An SM failure was detected.85387105
0iThere is insufficient shared
memory in DKC. Call
technical support.
There is insufficient shared
memory to create 4096
pairs.
85397105
0iCall technical support.There is sufficient shared
memory to create 4096
pairs, but initial subsystem
setup is required before
creating pairs.
85407105
0iClose the message box.There is sufficient shared
memory to create 4096
pairs, and the initial
subsystem setup is complete.
85417105
0iCall technical support.Failed to complete the initial
shared memory setup.
85427105
0iCall technical support.The shared memory size is
different.
85437105
0iCheck the contents, and retry.16 Mbytes of shared memory
is available.
85447105
0iCall technical support.A power supply failure is
detected.
85457105
0iRetry the operation with
power ON.
The command was rejected.
The PS OFF is in progress.
85467105
0iCall technical support.A data transfer failure is
detected (CHIP.)
85477105
0iCall technical support.A data transfer failure is
detected (ACP.)
85487105
0iYou cannot execute the
operation for the volume
which is not implemented.
The S-VOL is not
implemented.
85497105
0iCall technical support, and
check if the volume status is
normal.
The S-VOL cannot be used.85507105
0iWait until the volume is
formatted, and retry the
operation.
The S-VOL is being formatted.85517105
0iAs the S-VOL, specify a
volume that is not used as a
command device.
This volume cannot be
specified as an S-VOL
because it is used as a
command device.
85527105
XP Remote Web Console Error Codes 303