HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 62 Error Codes — Part Code 7105
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
2EIf this problem persists, call
technical support.
An error occurred during SVP
processing. If this problem
persists, call technical
support.
50997105
0iSelect the OK button.You cannot create another
pair, because the number of
pairs in the group exceeds
the maximum.
56257105
0iSelect the OK button.The specified volume cannot
be used because it is
write-protected by Volume
Retention.
56267105
0iSpecify other volume(s), or
release the XP Flex Copy
setting.
This operation has been
rejected. The specified
volume(s) are being used by
XP Flex Copy.
56547105
0iSpecify the volume(s) which
are not XP Flex Copy
volume(s.)
The specified volume(s) are
Cross-system Volumes and
cannot be used to create a
pair.
56567105
0iWait for a while, and retry
the operation.
Processing in progress. Wait
for a while, and then retry the
operation.
65027105
0iWait for a while, and retry
the operation.
The volume status is being
changed to simplex.
65037105
0iTake one of the following
actions:
• Change the attribute of
the Security Group so that
the specified volumes can
be R-VOLs or T-VOLs.
• Release the specified
volumes from the Security
Group so that the volumes
can be R-VOLs or T-VOLs.
The operation was rejected.
This is because the specified
volumes are defined in the
Security Group, and the
Security Group does not
allow the volumes to be
R-VOLs or T-VOLs.
65207105
0WIf this problem persists, call
technical support.
This error code is not
registered.
73107105
0iCheck if the necessary key
for the program product is
installed.
The program product is not
installed.
85007105
0iWait for a while, and retry
the operation.
The command was rejected,
because a status transition
was in progress.
85017105
0iDelete the Continuous Access
pair.
You cannot reserve the
volume, because a
Continuous Access pair exists
in the same subsystem frame.
85027105
0iDelete the Continuous Access
pair.
You cannot create the new
pair, because a Continuous
Access pair exists in the same
subsystem frame.
85037105
300 HP StorageWorks XP Remote Web Console for Storage System Messages and Error Codes