HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 59 Error Codes — Part Code 7005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
3ESelect another window. To
set this function, contact the
storage administrator.
This function cannot be used
by the storage partition
administrator.
565247005
2EIf this problem persists, call
technical support.
An error occurred during SVP
processing. If this problem
persists, call technical
support.
571017005
2EIf this problem persists, call
technical support.
An error occurred during SVP
processing. If this problem
persists, call technical
support.
571027005
0iSelect a different volume or
release the consistency group
setting.
The command has been
rejected because the cascade
request for creating cascade
pairs composed of volumes
belonging to the same
consistency group was
issued.
580007005
0iWait until the L1 pair status
changes to PSUS, and then
retry the operation.
The Paircreate command for
creating the L2 pair has been
rejected because the L1 pair
is in PSUS(SP) status.
580017005
0iQuick restore operation
cannot be performed when
the pair is composed of a
normal volume and a
customized volume (CV.)
Select a different pair.
The Quick Restore command
has been rejected because
the specified pair is
composed of a normal
volume and a customized
volume (CV.)
580027005
0iTo continue the operation,
delete the Continuous Access
pair.
The command has been
rejected because a
Continuous Access pair exists
in the same subsystem frame.
580037005
0iThe requested operation
cannot be performed. Check
the status of the specified
volume.
The command has been
rejected because the issued
request is an operation that
cannot be performed with a
volume that can be used from
either the mainframe or
open-system hosts.
580047005
0iStop using the specified pair
for Continuous Access, or
specify a different pair, and
then retry the operation.
The Quick Restore command
has been rejected, because
the specified pair is
composed of internal and
external volumes, and also
used as a Continuous Access
pair.
582597005
0iChange the status of the
Continuous Access pair, and
then retry the operation.
The Reverse Copy or Quick
Restore command has been
rejected, because the P-VOL
is also used as the P-VOL of
a Continuous Access pair
whose status is not Suspend.
582607005
XP Remote Web Console Error Codes 293