HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 3 Error Codes — Part Code 0003 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
6ECorrect the settings, and then
retry.
Since a path is defined to an
XP Flex Copy LU, you cannot
set high-speed mode.
11980003
6ECorrect the settings, and then
retry.
When defining paths from
iSCSI ports, you can only
define paths to open-systems
volumes.
11990003
6EChange the parameter to a
path where the High Speed
mode/MIX mode can be set,
and then retry the operation.
The selection of High Speed
mode/MIX mode is invalid.
The specified port cannot be
changed to High Speed
mode/MIX mode.
12010003
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
High Speed mode/MIX mode
was specified. However,
there are addresses to which
High Speed mode/MIX mode
cannot be set in the Fibre
Addresses of the specified
ports.
12030003
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
High Speed mode/MIX mode
was specified. However,
there are topologies to which
High Speed mode/MIX mode
cannot be set in the
topologies of the specified
ports.
12040003
6ETo add a path, change the
attribute of the specified port
to Target or RCU Target.
You could not add the path
to the initiator or external
port.
13500003
6ECannot set to high-speed
mode because the port
attributes are mixed, or
cannot set to
internal/external mix mode
because the combination of
port attributes is different.
Check the port attributes, and
then retry the operation.
The high-speed or
initiator/external mix mode
cannot be set to the specified
port because of the attribute
of the port.
13510003
6ESince the port you are trying
to set is for Fibre XP
Continuous Access, you need
to delete the logical path,
and then set.
Logical paths remain on the
Fibre-MCU port. This
operation may cause a fatal
damage to the logical paths.
Stop this operation. To
continue this operation,
remove the logical paths from
the MCU port first.
13520003
6ESince the port you are trying
to set is for Fibre XP
Continuous Access, you need
to delete the S-VOL logical
path which is set to RCU
Target, and then set.
S-VOLs remain on the
Fibre-RCU port. This
operation may cause a fatal
damage to S-VOLs. Stop this
operation. To continue this
operation, remove the S-VOLs
from the RCU port first.
13530003
XP Remote Web Console Error Codes 29