HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 59 Error Codes — Part Code 7005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0iCheck if the necessary key
for the program product is
installed.
The program product is not
installed.
85007005
0iWait for a while, and retry
the operation.
The command was rejected,
because a status transition
was in progress.
85017005
0iDelete the Continuous Access
pair.
You cannot reserve the
volume, because a
Continuous Access pair exists
in the same subsystem frame.
85027005
0iDelete the Continuous Access
pair.
You cannot create the new
pair, because a Continuous
Access pair exists in the same
subsystem frame.
85037005
0iThe operation failed, because
of one of the following
reasons:
1. You cannot execute the
operation on the specified
pair / volume.
2. The pairs of the Normal
volume and CV cannot
execute QuickRestore.
Check the pair or volume
status.
The command was rejected.85047005
0iCall technical support.The requested command is
invalid.
85057005
0iChange the specified S-VOL
to other volume, or stop using
the S-VOL in the host or
Continuous Access, and then
retry the operation.
The command was rejected.
The specified S-VOL is being
used from the host or by a
Continuous Access volume.
85067005
0iYou cannot execute the
Pairsplit command because
the pair is already in the
PSUS status.
The Pairsplit command was
issued to the pairs in a PSUS
status.
85077005
0iYou cannot execute the
Pairsplit command because
the pair is already in the
PSUS status.
The Paircreate command was
issued to the pairs in a PSUS
status.
85087005
0iCheck the contents, and retry.The Split command with the
QUIESCE specification was
issued to a secondary boot
device.
85097005
0iCheck the contents, and retry.The M-VOL Suspend
command was issued to a
secondary boot device.
85107005
0iDetach the S-VOL from the
host, or delete the Continuous
Access path.
You cannot reserve the
volume, because a path
group is set.
85117005
XP Remote Web Console Error Codes 283