HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 57 Error Codes — Part Code 6805 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
5WCorrect the setting, and then
retry. If the same problem
persists despite retrying, call
technical support.
The Level 2 Suspend setting
is incorrect.
552166805
5WSpecify the number of SLPRs
within the valid range.
The maximum number of
SLPRs that can be set was
exceeded.
552176805
5WCorrect the setting, and then
retry. If the same problem
persists despite retrying, call
technical support.
The Level 1 Sleep setting is
incorrect.
552186805
5WCorrect the setting, and then
retry. If the same problem
persists despite retrying, call
technical support.
The Sleep Time setting is
incorrect.
552196805
5WCorrect the setting, and then
retry. If the same problem
persists despite retrying, call
technical support.
The SLPR number is
duplicated.
552206805
5WCorrect the setting, and then
retry. If the same problem
persists despite retrying, call
technical support.
The CLPR number is
duplicated.
552216805
3ESelect another window. To
set this function, contact the
storage administrator.
This function cannot be used
by the storage partition
administrator.
565246805
Table 58 Error Codes — Part Code 6810
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0WThe operation has been
rejected because there is no
data to set. Select [OK], and
then go on to the next
operation.
No data has been changed.51226810
2EIf this problem persists, call
technical support.
An error occurred during
processing. If this problem
persists, call technical
support.
74406810
0iTo cancel the operation,
select [OK].
Do you want to cancel?91016810
0iTo execute the operation in
Preset, select [OK].
Do you want to apply?91026810
0iTo change the mode, select
[OK]. To not change the
mode, select [Cancel].
The value that is under setup
is not reflected yet. Do you
want to change the mode?
91066810
0iTo continue processing, select
[OK]. To stop processing,
select [Cancel].
The value that is under setup
is not reflected yet. Do you
want to continue the
operation?
91076810
280 HP StorageWorks XP Remote Web Console for Storage System Messages and Error Codes