HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)
Table 56 Error Codes — Part Code 6610 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0iSelect [OK]. Apply the preset
data to the disk storage
system, and then retry the
operation.
Since the number of preset
data exceeded the maximum,
the excess data were
discarded. No more preset
data can be stored.
590096610
0WCheck the contents of the
primary and secondary
volumes. If the contents
match, select [Yes].
Otherwise, select [No].
WARNING:
Initial copy mode None is
selected for some volume
pair. Are you sure that the
primary data volume and the
secondary data volume of the
pair are already
synchronized?
590106610
0WTo overwrite the file, select
[Yes]. Otherwise, select [No].
The specified file already
exists. Do you want to
overwrite this file?
590136610
0WCheck the DKC setting.The same DKC is specified
more than once. Check the
DKC setting.
590266610
5iTo continue the operation,
select [OK]. To cancel the
operation, select [Cancel].
Note that the current
monitoring data will be
deleted if you change the
setting of monitoring switch.
If necessary, use Export Tool
of XP Auto LUN Base Monitor
to export the monitoring data
file.
The monitoring data saved at
present will be deleted.
590306610
5iTo continue processing, select
[OK]. To stop processing,
select [Cancel].
Note that the monitoring data
saved at present will be
deleted when you change the
setting of the monitoring
switch. If necessary, save the
monitoring data by using the
Export Tool.
The monitoring data saved at
present will be deleted when
the monitoring switch is set to
Enable the next time.
590316610
0WPurchase a license for Hitachi
Universal Replicator for
z/OS, and then install it.
You cannot add journal
volumes because Hitachi
Universal Replicator for z/OS
is not installed.
590406610
274 HP StorageWorks XP Remote Web Console for Storage System Messages and Error Codes