HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 54 Error Codes — Part Code 6510 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0iCheck the number of journal
volumes in the specified
journal group, or check the
number of the selected
volumes.
No more journal volumes can
be registered, or too many
volumes are selected.
590066510
0iTo delete the specified
storage system, select OK. If
not, select Cancel.
Are you sure you want to
delete the specified
subsystems?
590076510
0iTo delete the specified path,
select OK. If not, select
Cancel.
Are you sure you want to
delete the paths of the
storage subsystem?
590086510
0iSelect the OK button. Apply
the preset data to the disk
storage system and then retry
the operation.
Since the number of Preset
data exceeded the maximum,
the excess data were
discarded. No more Preset
data can be stored.
590096510
0WCheck the contents of the
primary and secondary
volumes. If the contents
match, select [Yes]. If not,
select [No].
WARNING:
Initial copy mode None is
selected for some volume
pair. Are you sure that the
primary data volume and the
secondary data volume of the
pair are already
synchronized?
590106510
0WTo overwrite the file, select
[Yes]. Otherwise, select [No].
The specified file already
exists. Do you want to
overwrite this file?
590136510
0WCheck the DKC setting.The same DKC is specified
more than once. Check the
DKC setting.
590266510
5iTo continue the operation,
select [OK]. To cancel the
operation, select [Cancel].
Note that the current
monitoring data will be
deleted if you change the
setting of monitoring switch.
If necessary, use Export Tool
of XP Auto LUN Base Monitor
to export the monitoring data
file.
The monitoring data saved at
present will be deleted.
590306510
5iTo continue processing, select
[OK]. To stop processing,
select [Cancel].
Note that the monitoring data
saved at present will be
deleted when you change the
setting of the monitoring
switch. If necessary, save the
monitoring data by using the
Export Tool.
The monitoring data saved at
present will be deleted when
the monitoring switch is set to
Enable the next time.
590316510
XP Remote Web Console Error Codes 265