HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 54 Error Codes — Part Code 6510 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0iSelect [OK], and then specify
the correct volume.
The specified volume was not
found.
91286510
0iSelect the OK button.The history file has been
updated. Select the OK
button to display the history
logs from the beginning.
91556510
0WCheck the device emulation
or the definition of the SCSI
path.
There are no valid volumes.93036510
0WSet the port to Initiator before
registering the storage
system.
There are no initiator ports.93056510
5WObtain a license for XP
Continuous Access Journal,
and then install it.
The XP Continuous Access
Journal function is not
installed in this controller.
You cannot create pairs.
93066510
0WSince there are duplicated
paths in the added paths, the
duplicated paths will be
eliminated. Select the OK
button to continue.
You set the same path more
than once. The duplicate
paths are excluded.
93086510
0WSince all the added paths are
redundant, the paths cannot
be added. Select the OK
button and continue.
All paths which you set have
already been registered. This
operation will terminate
because there is no path
which can be added.
93096510
0iSelect the Refresh button to
update the history file. If this
problem persists, call
technical support.
The monitoring time is over,
but the history file is not fully
updated yet.
93276510
0iSelect the OK button, and
then continue the operation.
This operation is not applied
yet.
93326510
0iCheck the number of data
volumes in the journal group.
After that, delete unused data
volume pairs, or register them
in another journal group.
Too many data volumes in
the journal group.
550366510
0iCheck the number of mirrors
in the journal group. After
that, delete unused mirrors,
or register them in another
journal group.
Too many mirrors in the
journal group.
550376510
0iCheck the number of mirrors
in the journal group, and
then delete unused mirrors.
Too many mirrors in the
subsystem.
550386510
0iCheck the range setting. If
you specify Group, select
only one data volume pair in
the mirror.
You are specifying Group for
the range and trying to
manipulate the same mirror.
Select only one data volume
pair in the mirror when you
specify Group for the range.
550396510
XP Remote Web Console Error Codes 263