HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 52 Error Codes — Part Code 6505 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0WCheck the specified
secondary data volume and
specify a non-LUSE volume.
The Add Pair (Paircreate)
operation failed because the
specified secondary data
volume is a LUSE volume.
583446505
0WMake sure that the IO
suppression mode of the
specified secondary data
volume is enabled on the XP
External Storage Software
window. If the IO suppression
mode is disabled, check the
microcode version of
DKCMAIN of the secondary
storage system, and call
technical support.
The Add Pair (Paircreate)
operation failed due to one
of the following reasons:
• The IO suppression mode
of the specified secondary
data volume is enabled.
• The microcode version of
the secondary subsystem
does not support external
volumes.
583456505
0WFrom the XP LUN Security
Extension Software window,
check the settings of the
specified secondary data
volume.
The Paircreate operation
failed because a XP LUN
Security Extension Software
VMA was set up on the
specified secondary data
volume.
583466505
0WCheck the setting of the
specified secondary data
volume in the Volume Security
window.
The Add Pair (Paircreate)
operation failed because of
a Volume Security setting on
the specified secondary data
volume.
583476505
0WFrom the XP LUN Security
Extension Software window,
check the settings of the
specified primary data
volume.
The Paircreate operation
failed because a XP LUN
Security Extension Software
VMA was set up on the
specified primary data
volume.
583486505
0WFrom the Volume Retention
window, check the settings of
the specified primary data
volume.
The Add Pair operation failed
because the specified
primary data volume had a
Protect attribute set by
Volume Retention .
583496505
0WCheck the status of the
specified primary data
volume.
The Add Pair (Paircreate)
operation failed because the
specified primary data
volume was an external
volume, or the volume was
used by XP Flex Copy.
583506505
0WCheck the status of the
primary data volume in the
XP Business Copy window or
the Hitachi ShadowImage for
z/OS window.
The Add Pair (Paircreate)
operation failed because the
specified primary data
volume was one of the
following:
• an XP Business Copy
S-VOL
• a Hitachi ShadowImage
for z/OS T-VOL
• a reserved volume
583526505
XP Remote Web Console Error Codes 243