HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 3 Error Codes — Part Code 0003 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
2EThe setting method of
command device/command
device security is incorrect.
The following settings are
invalid.
1. Set command device +
Release command device
security
2. Release command device
+ Set command device
security
It does not occur normally
because it is guarded in the
screen. Contact the program
maker.
The command device setting
and the command device
security setting are incorrect.
You cannot do any of the
following to the same volume:
• Specify the volume as a
command device and
disable command device
security on the volume.
• Specify the volume as a
non-command device and
enable command device
security on the volume.
11240003
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
There are no host groups
where the WWN will be
registered.
11250003
6ECorrect the specified
contents, and request again.
A volume set as a command
device cannot be used as a
component of a LUSE volume.
Select another volume.
11260003
2ECHIP high-speed mode is
specified to unmounted CHIP.
The error does not occur
normally because it is
guarded in the screen.
Contact the program maker.
An error occurred. If this
problem persists, call
technical support.
11270003
2EChannel speed change is
requested, but Fibre PCB
does not support it. The error
does not occur normally
because it is guarded in the
screen. Contact the program
maker.
An error occurred. If this
problem persists, call
technical support.
11280003
2EWhen WWN is registered in
XP LUN Configuration and
Security Manager Software
operation, the number of
WWNs you can register is
exceeded. The error does not
occur normally because it is
guarded in the screen.
Contact the program maker.
An error occurred. If this
problem persists, call
technical support.
11290003
6ECorrect the specified
contents, and request again.
You cannot specify the
default nickname when
setting the nickname of a host
group or a host.
11300003
24 HP StorageWorks XP Remote Web Console for Storage System Messages and Error Codes