HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 52 Error Codes — Part Code 6505 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
4WCheck whether the primary
data volume is in any of the
following conditions:
• Data in the primary data
volume is being copied;
correction copy or drive
copy is in progress.
• The primary data volume
is in correction access
condition.
• The primary data volume
is blocked.
• The primary data volume
is being maintained.
• The access attribute of the
primary data volume is
Read Only.
The specified primary data
volume cannot be used.
87446505
4iCheck whether the secondary
data volume in the remote
storage system, which are
connected from hosts or the
SVP, is in any of the
following conditions:
• The secondary data
volume is being used by
Dual Copy.
• The secondary data
volume is being used by
Hitachi Extended Remote
Copy for Mainframe.
• The secondary data
volume is being used by
PPRC or Continuous
Access.
• The secondary data
volume is being used by
Concurrent Copy.
• The access attribute of the
secondary data volume is
Read Only.
The secondary data volume
is already in use by another
system.
87456505
4iSee the INSTALLATION
SECTION and the
OPENPLATFORM SECTION
in the maintenance manual
to check if the device
emulation of the primary data
volume is supported.
The emulation type of the
primary data volume is not
supported by XP Continuous
Access Journal or Hitachi
Universal Replicator for
z/OS.
87466505
4iCheck if the secondary data
volume is online. If the
secondary data volume is
online, vary the volume
offline, and then retry the
operation. If the secondary
data volume is connected to
a VM system, vary the volume
offline from the VM system.
The specified secondary data
volume is online.
87496505
224 HP StorageWorks XP Remote Web Console for Storage System Messages and Error Codes