HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 50 Error Codes — Part Code 6010 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0WCheck the entered values,
and then specify correct
values.
Some of the entered values
are incorrect. Check the
values and then specify
correct values.
51446010
2ECall technical support.A client processing error
occurred.
70606010
2ECall technical support.A client processing error
occurred.
73016010
2ECall technical support.A client processing error
occurred.
73026010
2ECall technical support.A client processing error
occurred.
73036010
2EIf this problem persists, call
technical support.
An error occurred during
processing. If this problem
persists, call technical
support.
74406010
5WSelect [Refresh], and retry.The system cannot apply the
new configuration. Do you
want to refresh?
81016010
0WSuspend the specified pair,
and perform the operation to
resume the pair.
An error occurred when
copying started.
89286010
0WIf nothing changes despite
retrying, call technical
support.
XP Snapshot has failed.90036010
0iSelect [OK].XP Snapshot is done.90046010
5WThe same as the message.Exchange the channel cable
connections after
confirmation of the port type.
90066010
0WConfirm that the R-VOLs to
specify are varied off-line.
Confirm that the R-VOLs to
specify are varied off-line.
90076010
0iSelect [OK].SIMs of Continuous Access
are cleared.
90086010
0iSelect [OK].XP Snapshot is complete.90096010
5WSelect Yes to continue
processing. After processing
is complete, reset the port
that is not in operation.
The Port Setting process has
not completed. Do you want
to continue for other ports?
90216010
0WCheck the contents of the
main and remote volumes. If
the contents match, select
[OK]. If not, select [Cancel].
WARNING: Initial copy
mode None is selected for
some volume pairs. Are you
sure that the M-VOL and the
R-VOL of these pairs are
already synchronized?
90226010
0WIf you re-execute snapshot by
overwriting the existing
snapshot, select OK. If you
need to migrate the existing
snapshot, select Cancel. And
retry after the migration.
Are you sure you want to
output pair status into a
snapshot file? (Warning:
Snapshot file will be
overwritten.)
90236010
212 HP StorageWorks XP Remote Web Console for Storage System Messages and Error Codes