HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 48 Error Codes — Part Code 6005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
4iThe suspend pair (Pairsplit-r)
operation failed. A few
minutes later, refresh the
screen, confirm if the
specified volumes are in the
permissible status, and then
retry the operation.
Wait a few minutes and retry
the Suspend Pair (Pairsplit-r)
operation.
88486005
4iThe specified volume is not
part of a Continuous Access
pair. Check the volume.
Specified volume is not part
of Continuous Access pair
(Not in Duplex (PAIR),
Pending (COPY), Suspend
(PSUS) state.)
88496005
4ECheck the serial number,
SSID, link address and
controller ID of the RCU, and
set the correct value. Then
retry the operation. If the
same error occurs, contact
technical support.
Invalid RCU serial number,
SSID, Link Address or
Controller ID.
88506005
4ECheck the R-VOL status.Invalid R-VOL.88516005
4EConfirm the R-VOL status.R-VOL status change failed
after M-VOL status change.
Confirm R-VOL status.
88526005
4iData migration could not be
started. Check the status of
the volume, because the
specified volume may be
online, or migration copy
may be in progress.
Data Migration volume pair
cannot be terminated
because migration copy is in
progress or the specified
volume may in use by HOST.
88536005
4iThe operation failed, because
of one of the following
reasons:
1. The specified volume is
simplex.
2. There is no duplex,
duplex-pending, or
suspend volume in the
group. Verify the status,
and retry the operation.
Delete Pair (Pairsplit-S)
operation failed because
M-VOL is in Simplex (SMPL)
status.
88546005
196 HP StorageWorks XP Remote Web Console for Storage System Messages and Error Codes