HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 48 Error Codes — Part Code 6005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
4WConfirm the status of the
specified R-VOL. See the
OPENPLATFORM SECTION
in the maintenance manual
to confirm whether the device
emulation type of the R-VOL
is supported by XP
Continuous Access via serial
interface.
The specified R-VOL is not
usable, or the device
emulation type of the R-VOL
is not supported by XP
Continuous Access via serial
interface.
87646005
4iThe device emulation type of
the specified M-VOL does not
support data migration. Call
technical support.
Data Migration is not
supported under the M-VOL
Device emulation type.
87656005
4iThe device emulation type of
the R-VOL does not support
XP Continuous Access. Call
technical support.
XP Continuous Access is not
supported under the R-VOL
Device emulation type.
87666005
4iThe R-VOL device emulation
type does not support data
migration. Call technical
support.
Data Migration is not
supported under the R-VOL
Device emulation type.
87676005
4EThe RCU containing the
R-VOL is being used as the
RCU for XP Continuous
Access. Verify the status of
the RCU, if necessary delete
the RCU, and then retry the
operation.
The RCU is still in another XP
Continuous Access condition.
87686005
4EThe RCU containing the
R-VOL is being used as the
RCU for XP Continuous
Access. Verify the status of
the RCU.
The RCU is still in another XP
Continuous Access condition.
87696005
4iSelect [OK] to acknowledge
the message, and then retry
the operation after the cache
has been recovered.
The Cache on the MCU is
automatically recovering.
Wait a few minutes then retry
again.
87706005
4iThe R-VOL option change
operation failed (only the
M-VOL option was modified),
because the RCU side does
not support the display fence
level function.
R-VOL option change
operation failed. Only M-VOL
option was modified because
RCU side did not support a
fence level displaying
function.
87716005
XP Remote Web Console Error Codes 187