HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 38 Error Codes — Part Code 4010
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
0iCorrect the specified content,
and issue the request again.
Part of the range is already
in use.
10304010
0iCorrect the specified content,
and issue the request again.
The specified value is outside
the valid range.
10324010
6EWait for a while, and press
the Refresh button, and then
change the same
configuration again. Or
check the DKC status (if it is
not blocked.) If the same
error occurs, call technical
support.
Prestaging not completed.20804010
5WCorrect the values specified
as the starting and ending
addresses, and then retry the
operation.
The value specified as the
ending address for the data
to be placed in cache is
smaller than the value
specified as the starting
address.
50104010
5WCorrect the specified content,
and retry.
The value specified as the
Number of XP Cache LUN
Software areas is equal to or
less than one cylinder.
50114010
5WCorrect the specified content,
and retry.
No deletion area is specified.
Retry the operation to specify
the deletion area.
50304010
5WCorrect the XP Cache LUN
Software settings, and then
retry the operation.
The XP Cache LUN Software
settings that exceed the
maximum size or maximum
available area are invalid.
50584010
2ECall technical support.An error occurred in the client
logic.
70604010
2EAn error occurred. If this
problem persists, call
technical support.
An error occurred during
processing. If this problem
persists call technical support.
74404010
0iThe normal end was carried
out. Select the OK button and
close the dialog.
Prestaging has completed.90004010
0iThe system will set the
contents.
90104010
0iDo you want to delete?90604010
5WThe information for the
program product will be
called off if you select OK
button. The information will
not be called off if you select
Cancel button
Are you sure you want to
reset the P.P. information?
93404010
0iTo perform the prestaging
operation, select [Yes] button.
To not perform the prestaging
operation, select [No] button.
Prestaging will be carried out
to the selected LDEV. Do you
want to continue?
590354010
152 HP StorageWorks XP Remote Web Console for Storage System Messages and Error Codes