HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 26 Error Codes — Part Code 1005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
6ECheck the setting.The value of the iSCSI name
is not specified or is set to
zero.
555581005
6ECheck the setting.The specified package
cannot be set because the
package is for iSCSI.
555591005
6ECheck the setting.The fibre address, topology,
channel speed, and
Initiator/Target cannot be
changed because the
specified port is an iSCSI
port.
555601005
2EIf this problem persists, call
technical support.
An error occurred during SVP
processing. If this problem
persists, call technical
support.
555611005
6ESpecify another LU.The specified LU cannot be
used as a system LU of a
NAS or has already been
used.
555621005
6ESpecify another LDEV.The specified LDEV cannot be
defined as a system LU of the
NAS.
555631005
6EDelete the user LU, and then
delete the system LU.
The specified system LU
cannot be deleted because a
NAS user LU exists.
555651005
2EIf this problem persists, call
technical support.
An error occurred during SVP
processing. If this problem
persists, call technical
support.
555661005
6ECheck the settings, and then
retry the operation.
No path can be configured
for NAS because the
specified volume is a V-VOL.
555671005
6ECheck the setting.The nickname of the specified
target name or iSCSI name
is already registered.
555681005
6ECheck the setting.The specified Group-ID is
already registered.
555691005
6ECheck the setting.The character or the number
of characters that cannot be
specified was specified in
target name, target alias,
iSCSI name and the
nickname of iSCSI name.
555701005
6ECheck the setting.The target cannot be set
because the number of
targets exceeds the maximum
that can be set in a port.
555711005
114 HP StorageWorks XP Remote Web Console for Storage System Messages and Error Codes