HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 26 Error Codes — Part Code 1005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
In the linkage operation
including LUSE, the path is
specified to other than the
top.
11861005
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
You cannot expand the LU
because the host mode of the
group with paths which are
defined in the LU is
corresponding to online
LUSE.
11871005
2EIf this problem persists call
technical support.
An error occurred. If this
problem persists call technical
support.
11881005
6EDelete a file system
configured on the user LU,
and then retry.
Failed to delete the specified
user LU because it is being
used by the NAS package.
To delete the specified user
LU, delete the file system
configured on the LU that is
set by this user LU.
11891005
6ECorrect settings and then
retry.
To define a path to the
volume from a NAS port or
an iSCSI port, the volume
must be read/write-enabled
and also usable as an S-VOL
(secondary volume.)
11901005
6ECorrect the settings, and then
retry.
No information can be
changed about this external
port because the port has an
external volume.
11941005
6ECorrect the settings, and then
retry.
The specified volume(s) are
used as a command device.
11951005
6ECorrect the settings, and then
retry.
You cannot create a LUSE
volume by concatenating LUs
and XP Flex Copy LUs.
11961005
6ECorrect the settings, and then
retry.
You cannot set high-speed
mode to a package including
an external port.
11971005
6ECorrect the settings, and then
retry.
Since a path is defined to an
XP Flex Copy LU, you cannot
set high-speed mode.
11981005
6ECheck the setting.The path cannot be set to the
specified volume because the
volume is not an
open-systems volume.
11991005
6EChange the parameter to a
path where the High Speed
mode/MIX mode can be set,
and then retry the operation.
The selection of High Speed
mode/MIX mode is invalid.
The specified port cannot be
changed to High Speed
mode/MIX mode.
12011005
XP Remote Web Console Error Codes 107