HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 26 Error Codes — Part Code 1005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
There are no host groups
where the WWN will be
registered.
11251005
6ECorrect the specified
contents, and request again.
A volume set as a command
device cannot be used as a
component of a LUSE volume.
Select another volume.
11261005
2ECHIP high-speed mode is
specified to unmounted CHIP.
The error does not occur
normally because it is
guarded in the screen.
Contact the program maker.
An error occurred. If this
problem persists, call
technical support.
11271005
2EChannel speed change is
requested, but Fibre PCB
does not support it. The error
does not occur normally
because it is guarded in the
screen. Contact the program
maker.
An error occurred. If this
problem persists, call
technical support.
11281005
6ECorrect the specified
contents, and request again.
You cannot specify the
default nickname when
setting the nickname of a host
group or a host.
11301005
6ENo more host groups can be
set, because the number of
host groups has reached the
maximum (254) that can be
set in a port. Reduce the
number of host groups, and
then retry the operation.
No more host groups can be
set, because the number of
host groups has reached the
maximum (254) that can be
set in a port.
11311005
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
Failed to set the WWN
because the number of
WWNs exceeds the
maximum that can be set in
a port.
11321005
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
Failed to set the host mode
because the number of host
modes exceeds the maximum
that can be set in a port.
11331005
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
Failed to set the path because
the number of paths exceeds
the maximum that can be set
in a port.
11341005
104 HP StorageWorks XP Remote Web Console for Storage System Messages and Error Codes