HP StorageWorks XP Remote Web Console Error Codes: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96057, May 2011)

Table 26 Error Codes — Part Code 1005 (continued)
Failure
Level
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
You are trying to register the
same host group number as
the already registered one.
10671005
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
The specified host group has
not been registered.
10681005
2ECommand device setting is
requested for Reserve volume
of XP Auto LUN/On Demand
volume. Or it is requested for
volumes other than open
volumes (including
un-installed volumes.) The
error does not occur normally
because it is guarded in the
screen. Contact the program
maker.
When changing the
configuration of the
command device, you cannot
set the command device to
the following volumes:
• Reserved volumes for XP
Auto LUN
• Just-in-Time volumes
• Volumes other than the
open-system volumes
(including unmounted
volumes)
11081005
2EIf this problem persists, call
technical support.
An error occurred. If this
problem persists, call
technical support.
11101005
2EA nickname is not specified
when the configuration
change of XP LUN
Configuration and Security
Manager Software is
requested. The error does not
occur normally because it is
guarded in the screen.
Contact the program maker.
An error occurred. If this
problem persists, call
technical support.
11111005
2EYou have not specified the
value when registering
WWN. Or zero is set as the
WWN value. The error does
not occur normally because
it is guarded in the screen.
Contact the program maker.
An error occurred. If this
problem persists, call
technical support.
11161005
6EThe Configuration information
has been already changed.
Check the settings and
request the setting of the
configuration information
again.
Command device security
cannot be set to the specified
volume because the volume
is not a command device.
11231005
XP Remote Web Console Error Codes 103