HP StorageWorks XP LUN Configuration and Security Manager User Guide: HP XP12000 Disk Array HP XP10000 Disk Array HP 200 Storage Virtualization System (T1714-96030, June 2010)

4. Right-click any port icon in the Port tree, and select Default Setting(User Name / Secret). The
Default Setting(User Name/Secret) pane appears.
Figure 68 Default Setting(User Name/Secret) pane
.
Specify the following user information:
• User Name: Fiber Channel's user name, up to 16 characters. You can use alphanumeric
characters in a user name. User names are case-sensitive.
• Secret: Secret (that is, a password used in CHAP authentication) between 12 to 32 characters.
You can use alphanumeric characters.
• Re-enter Secret: Specify the secret, again, for confirmation.
5. Click OK.
6. Click Apply. A confirmation message appears.
7. Click OK. Settings are applied to the array.
Registering a Fibre Channel switch's user information
1. Start XP LUN Configuration and Security Manager Software, and display the Authentication pane
(Figure 30).
2. In the Port tree, double-click the Subsystem folder. If the array contains Fibre Channel adapters,
the Fibre folder appears below the Subsystem folder.
3. In the Port tree, double-click the Fibre folder. Information about the Fibre Channel switch appears
in the FC Switch Information list.
XP LUN Configuration and Security Manager User Guide 135